Forum Title: Add micro bevel to t&g hardwood floor board

Some of my t&g solid oak floor boards will have to be cut on an angle to abut a header board. I have a router bit to cut the groove and am looking for suggestions on the best way to cut the micro bevel on the top edge. The boards are 2 1/4 inch wide, 3/4 inch thick and are prefinished. I could route with a chamfer bit, cut on the miter saw, use a sander. Would like your recommendations. Thank You

Category: Flooring Post By: MITCHELL VAZQUEZ (Denton, TX), 02/12/2019

Low angle block plane

- TRACY YANG (Kalamazoo, MI), 05/11/2019

Post Answers

Vinyl Flooring Cost Carpet Shampooer Near Me Tile Installation Companies

Quick Link